Small switch for temp sender changeover

[Dust]

Looking for a way to monitor temps, and want to find a small switch to mount near the guage so I can change between two sensors. Does anyone have any suggestions?

[veggiesub]

This thread mentions a rotary switch from radio shack:
http://www.frybrid.com/forum/showthr...tary#post79735

[green bus]

I use a 12V single-pole double-throw (SPDT) switch I picked up for cheap at the local hardware store.

I have one sender between the FPHE and the IP inlet, and one sender on the outlet of the IP. Wired both to the switch and toggle between them on the same gauge.

[Dust]

That's what I am looking for. The smaller the better. I want it to fit in te gauge mount. I will see what I can find when I get back to the states.