Installing Frybrid Kit on F350 with 7.3IDI engine?

[George_7.3IDI]

Hi Everyone,

I've got a frybrid kit that I've had since the end of last summer that I plan to install on my truck. I'm looking to get some advice on how to route the lines to prevent any kinks and where to position the solenoid valves. One of the problems I'm going to have is that I have a turbo on my truck so at the rear of the engine there isn't much room for installing the solenoid valve for the return line so I was hoping that I could find someone with a similar vehicle in order to get some tips on how they installed their kit. Also when running the supply line down the drivers side frame rail I was planning on turning at the front crossmember to get to the passenger side and then just follow the stock fuel line up into the engine compartment but I was wondering if the corner at the left and right side of the front crossmember would be too sharp for the aluminum fuel line and kink it inside the coolant line?

Anyways thanks for any help that can be provided
George